Filter
Top Products
7
Figure 5
ATTACHING THE CLUTCH CABLE
Attach the clutch cable to the handle as follows (be
careful not to kink the cable).
1. Route the clutch cable to the left side of the tiller,
and underneath the handle. Remove one hex
nut and lock washer from the end of the casing
on the clutch cable. Thread the other nut all the
way onto the threaded casing, as far as it will go.
2. Slip the wire through the slot on the cable
bracket on the handle. Push the end of the
casing up through the cable bracket. Slide the
lock washer on the casing and rethread the hex
nut on the end of the cable casing, four turns.
Do not tighten at this time. See Figure 5.
Figure 6
3. Pull the cable upwards to obtain slack, push the
"Z" end into the bail. You will need to attach "Z"
fitting from the inside to the outside.See Figure
6.
4. With the clutch control bail released, adjust the
bottom nut at the cable bracket three turns up
from end of threads. Tighten the upper nut
against the bracket. Carefully squeeze the clutch
control bail against the handle. The control wire
should now be straight.
NOTE: Do not overtighten control wire. Too much
tension may cause it to break.
WARNING: Be certain to check the
clutch cable adjustment as instructed
on page 7 of your owner’s guide before
operating the tiller.
Secure drive cable to handle using cable tie. Refer
to Figure 8. Cut off excess end of cable tie.
ATTACHING THE CONTROL ROD
1. Remove hairpin clips from control rod, (rubber
washers to remain on control rod).
2. Insert one end of the control rod through the
indicator bracket on the shift cover and secure
with hairpin clip that was removed in step 1. See
Figure 7.
3. Insert the remaining end of the control rod
through the hole in the gear selector handle and
secure with hairpin clip. See Figure 8.
.
Figure 7
CHECKING THE CLUTCH ADJUSTMENT
IMPORTANT:
Service the engine with oil and
gasoline before checking this adjustment. Refer to
the separate engine manual packed with your tiller
for proper fuel and engine oil recommendations.
Hex
Nut
Slot in
Cable Bracket
Nut
Hex
Washer
"Z" Fitting
Clutch Control
Bail
Indicator Bracket
Rubber
Washer
Control Rod
Hairpin
Clip
Idler
Pulley
Rod