Filter
Top Products
Document ID:1508000
0
Rev: E Technical Support: 80
0
-62
6
-691
2
Page 13 of 2
0
Installing and Removing the Side Panels
To install the side panels on your spa follow the instructions below:
Step 1: Slightly lift side panel into
place on spa frame.
Step 3: Make certain that the side
panels lay above the frame at
the top of the basin, as shown
above.
Step 5: Align the thumbscrew
holes located under cushion
skirt, and screw in the
thumbscrew.
Step 2: Align the magnets on the
frame legs with matching
brackets found on the inside of
the side panel. There is one set
on each leg.
Step 4: The si de panel should fit
under the lip of the basin, as
shown above.
Step 6: Install the front plate by
aligning the magnets to the
matching brackets and pressing
into place.
To remove side panels: Reverse steps one through six.
Installing the Floor Mounting Brackets
All Platino Spas installed with gravity drain and / or hard piped to hot and cold supply lines
MUST
be anchored to the floor.
To install the floor mounting brackets on your spa follow the instructions below:
Step 1: Adjust the leveling feet until you have at least
a ¼” gap.
Step 2: Place the floor mounting brackets on to
leveling feet diagonally from each other. (2
brackets provided)
Step 3: Mark spots to be drilled. Bracket has ½” hole. If mounting to floor, use (2) 3/8” floor lag bolts with
washer – not provided.