Filter
Top Products
- 7 -
4.
Attach Upper Post (F) to Lower Post (H) by screwing the two pieces of the post
together.
5. Place Tank Housing (D) onto Base (J). Slide Tank Housing (D) over
the assembled Upper/Lower Post and down over the Post Supports.
Rest Tank Housing on Base.
6. Attach Head Assembly (C) to Upper Post (F).
Note: There is a small piece of protective foam located in the
neck of the Head Assembly that MUST be removed prior to
attaching Head Assembly to the Upper Post.
Route Gas Hose (E) down into Upper/Lower post assembly and
align 4 small holes on Head Assembly with 4 Small holes in Upper
Post(F).
[HINT: Control knob should be above decal on post.]
Insert 4 M6x10 (FF) bolts through 4 M6 lock washers into holes and
tighten.
Hardware Used
: 4 x FF, Bolt M6x10 and Lock Washer M6
ASSEMBLY
4
5
6