Filter
Top Products
6
SERVICE
REPLACING THE LINE
S Disconnectunitfromthep owersource.
S Remove the spool by firmly pulling on
the tap button.
S Clean entire surface of hu b and spool.
S Repl acewith apre-wound spool,or cut a
leng th of 30 feet of 0.06 5 d iameter
WEED EATER br andline.Use ofheavi-
er li ne could overload and d amage the
unit. Ne ver use wire, rope , s tring, et c. ,
which c an break off and become a dan-
gerous missile.
S I nser t one e nd of the l i ne a bout 1/ 2 inch
(1cm) i ntothe smallslot i nside t hespool.
Small
Hole
Spool
S Wind the line evenly and tightly onto
the spool. Wind in the direction of the
arrow found on the spool.
S Push the line into the notch, leaving 3
to 5 inches (7 -- 12 cm) unwound.
S Insert the line into the exit hole in the
hub as shown in the illustration.
Hub
Line ex it hole
Line in
Notch
S Align the notch with the line ex it hole.
S Push the spool into the hub until it
snaps into place, while keeping light
tension on the end of the line.
S Pullonthelineextendingoutsideofthe
hub to release it from the notch; other-
wise, the unit will not function properly.
STORAGE
WARNING: Perform the following
steps after each use.
S Stop theunit anddisconne ct thepower
source when not in use.
S Carry the unit with motor stopped.
S Store the unit so the line limiter blade
cannot cause injury.
S Store unit and extension cord indoors
in a high, dry place out of the reach of
children. Store unit unplugged.
S Storeunitwithallguardsin place.Posi-
tion unit so that any sharp object can-
not accidentally cause injury.
NEED ASSISTANCE?
For assistance, or a replacement part
call: 1-800-554-6723.
Sa
f
ety Glasses 952701645
Spool with 30’ line 952701663
50’ coil of bulk line. 952701550
100’ coil of line. 952701533
200’ coil of line. 952701594