Filter
Top Products
7
D Specifically marked as suitable for out-
door use.The cord mustbe markedwith
the suffix “ W”.
D Heavy enough to carry full current from
the power source tothe unit.Otherwise,
loss of power and overheating can oc-
cur causing damage to unit. Refer to
table for minimum wire gauge recom-
mendations. The cord must be marked
with the proper wire gauge. (Appropri-
ate extension cords are available.) Do
not use multiple cords.
D In good condition. Cord i nsulation must
be intact with nocracks or deterioration.
Plug connectors must be undamaged.
DO NOT use multiple cords.
MINIMUM WIRE GAUGE
RECOMMENDATIONS
VOLTS
25 FT. 50 FT. 100 FT.
120 16
A.W.G.*
16
A.W.G.*
*American Wire Gauge
14
A.W.G.*
Secur e the ex t e nsion cor d to the uni t by
threa ding the co rd thro ugh the co rd re-
taine r (see illustratio n). Insert the cord
rece ptacl e int o the r ece ssed p l ug .
CAUTION: Failuretousecordretain-
er cou ld result in d amage to the unit,
extension cord, or both.
Cord
Retainer
Cord
Receptacle
Recessed
Plug
on Unit
USING YOUR UNIT
KNOW YOUR ELECT RIC BLOWER/VACUUM
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
UNIT.
Comp are the illustrations to yo ur unit to familia rize yourself with the location of
the various controls and adjustments. Sav e this manual for future reference.
Top Handle
Air Vents
ON
/
OFF Switch
Inlet Cover
Latch
Rear
Handle
Upper Vacuum Tube
Lower Va cuum Tube
Collection Bag
Blower Tube
Cord
Retainer
Inlet Restrict or
Vacuum As sist Handle
Tube Release Button
Elbow
Tube
Upper Va cuum Tube
Retaining Post
ON/OFF SWITCH
The
ON/OFF SWITCH is used to activate
the motor.
INLET COVER LATCH
The INLETCOVERLATCHis usedtoopen
and close the inlet cover and to secure
the up per vacuum tube to the blower
unit.