Filter
Top Products
ASSEMBLY
HOW TO SET UP YOUR TRACTOR
CHECK BA'B'ERY (See Fig. 2)
Lift seat pan to raised position and open battery box
door.
• If this battery is put into service after month and year
indicated on label (label located between terminals)
• - charge battery for minimum of one hour at 640 amps.
(See "BATTERY" in CUSTOMER RESPONSIBILITIES
section of this manual for charging instructions).
SEAT
BOX
LABEL
INSTALL SEAT (See Fig. 3)
Adjust seat before tightening adjustment bolt.
Remove adjustment knob and flat washer securing seat
to cardboard packing and set aside for assembly of seat
to tractor•
• Pivot seat upward and remove fror_ the cardboard
packing. Remove the cardboard packing and discard.
• Place seat on seat pan and assemble shoulder bolt,
Tighten shoulder bolt securely,
• Assemble adjustment bolt. Iockwasher and flat washer
loosely. Do not tighten.
Lower seat into operating position and sit on seat.
• Slide seat until a comfortable position is reached which
allows you to press clutch/brake pedal allthe way down.
• Get off seat without moving its adjusted position.
Raise seat and tighten adjustment bolt securely.
TERMIR
FIG. 2
SHOULDER \ _ \_\ \ \\\
BOLT _ \\ \_y_ _ \ \ \ \\ \
BOLT
FIG.3
NOTE: You may now roll or drive your tractor off the skid.
Follow the appropriate instruction below to remove the
tractor from the skid.
TO ROLL TRACTOR OFF SKID (See Operation
section, page 10, for location and function of
controls)
• Press liftlever plunger and raise attachment liftlever to
its highest position.
• Release parking brake by depressing clutch/brake pedal.
Place gearshift lever in neutral (N) position.
• Roll tractor forward off skid.
Remove banding holding discharge guard up against
tractor.
7