Filter
Top Products
SERVICE AND ADJUSTMENTS
T0,START ENGINE WITH A WEAK BAlTERY
TO REPLACE HEADLIGHT
BULB
(See
Fig.
25)
Raise hood.
*
Pull bulb holder out of the hole in the backside of the
grill.
ate explosive gases. Keep sparks,
flame and smoking materials away
a
Replace bulb in holder and push bulb holder secure-
from batteries. Always wear eye pro-
ly back into the hole in the backside of the grill.
tection when around batteries.
Close hood.
If your battery is too weak to start the engine, it should be
INTERLOCKS
AND
RELAYS
recharged-
If
rumper cables*
are used
emergency
Loose or damaged wiring may cause your tractor to run
starting, follow this procedure:
~oorlv, sto~ runninn. or prevent it from startina.
a.
.
-.
.
IMPORTANT:
'OUR
IS
EQU'PPED
A
l2
;
Check wiring. See electrical wiring in Repair
VOLT NEGATIVE GROUNDED SYSTEM. THE OTHER VEHI-
CLE MUST ALSO
BE
A
12
VOLT NEGATIVE GROUNDED
Parts section of this manual.
SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO
START OTHER VEHICLES.
TO
REPLACE
FUSE
TO
ATTACH
JUMPER CABLES
-
Connect each end of the RED cable to the POSITIVE
(+)
terminal of each battery, taking care not to short against
chassis.
=
Connect one end of the BLACK cable to the NEGATIVE
(-)
terminal of fully charged battety.
Connect the other end of the BLACK cable to good CHAS-
SIS GROLIND, away from fuel tank and battery.
TO
REMOVE CABLES, REVERSE
ORDER
-
BLACK cable first from chassis and then from the fully
charged battery.
RED cable last from both batteries.
Replace with
30
amp automotive-type plug-in fuse. The
fuse holder is located behind the dash.
TO REMOVE HOOD AND
GRILL ASSEMBLY
(See
Fig.
26)
Raise hood.
Unsnap headlight wire connector.
Stand in front of tractor. Grasp hood at sides, tilt
toward engine and lift off of tractor.
To replace, reverse above procedure.
FIG.
26
FIG.
25