Filter
Top Products
8
S Use a soft brush to remove debris from all
air intakes and the cutting blade.
S Wipe off unit with a clean dry cloth.
LUBRICATE BLADES
S Stopthemotoranddisconnecttheunitfrom
the power source.
S Remove any debris o n blades.
S Cleanallpartsandcheckfordamage.Have
damaged parts replaced. Be cautious of
sharp edges.
S Apply a light machine oil along the edge of
the top and bottom straps.
NOTE: Ensure handles remain clean and
dry.
STORAGE
WARNING: Perform the following
steps after each use.
S Stop the unit and disconnect the power
source when not in use.
S Carry the unit with motor stopped.
S Store the unit so the blades cannot cause
injury.
S Store unit and extension cord indoors i n a
high, dry place out ofthe reach of children.
Store unit un plugged.
S Store unit with all gua rds in place. Position
unit so that any sharp object cannot acci-
dentally cause injury.
TROUBLE CAUSE REMEDY
Unit fails to
operate
1. Con tact you r authorized service dealer.
2. Check Breaker Box.
3. Remove debris.
Cutting blades
stop under a
load or do not
move when
trigger switch
is pressed
1. Cut at a slower pace.
2. Clean debris from blades.
3. Plug unit into a 120 volt outlet.
4. Con tact yo ur authorized service dealer.
Poor cutting
quality
1. Ensure the product is being used
corr ectl y.
2. Clean debris from blades.
3. Contact your authorized service dealer.
Excessive
vibration
1. Con tact you r authorized service dealer.
TROUBLESHOOTING TABLE
1. Damaged blades.
1. Unit is being used
incorrectly.
2. Blades clogged with
debris.
3. Damaged blades.
1. Forcing blade into
material being cut.
2. Blades clogged with
debris.
3. Unit not plugged in.
4. None of the above
1. Electrical failure.
2. Thrown circuit breaker.
3. Debris stopping blade.
WARNING: Always stop unit and disconnect from the power source before per-
formingalloftherecommendedremedies belowexcept rem ediesthatrequireunit tobe
operating.