Filter
Top Products
8
USER REPLACEABLE SERVICE PARTS
Spool with 0.065 inch Trimmer Line 952711602
Line Guide Ring 530403949
Cap Assembly 530403810
Assist Handle 530403805
Bolt Carriage, 1/4 -20 530403886
Wing Nu t 530016152
Shield Assembly 530403914
Edge Guide 530403824
REPLACEMENT PART PART NUMBER
STORAGE
WARNING: Perform the following
steps after each use .
S Stop the unit and disconnect the power
source when not in use.
S Carry the unit with motor stopped.
S Store the unit so the line limiter blade can-
not cause injury.
S Store unit and extension cord indoors in a
high, dry place out of the reach of children.
Store unit unplugged.
S Store unit with all guards in place. Position
unit so that any sharp object cannot acci-
dentally cause injury.
TROUBLE CAUSE REMEDY
Trimmer head
stops under a
load or does not
turn when switch
is pressed.
1. Allow tip of line to do the cutt ing.
2. Contact your authorized service dealer.
3. Check breaker box.
4. Remove debris.
Line does not
advance or
breaks while
cutting.
1. Check line routing.
2. Rewind line tightly and evenly.
3. Use only 0.065 inch (1.65 mm) dia. line.
4. Remove cover and pull 4 inches
(10 cm) of line out of head.
5. Clean unit.
Line welds onto
spool.
1. Use only 0.065 inch (1.65 mm) dia. line.
2. Replace with correct spool.
3. Cut wit h tip of line fully extended.
Line releases
continuously.
1. Check line routing.
2. Replace spool.
Line pulls back
into head.
1. Too little line outside
of head.
2. Line size incorrect .
1. Remove cover and pull 4 inches
(10 cm) of line outside of head.
2. Use only 0.065 inch (1.65 mm) dia. line.
TROUBLESHOOTING TAB LE
1. Line im properly
routed in head.
2. Spool damaged.
1. Line size is incorrect.
2. Inco rrect spool.
3. Line is being crowded
against material being
cut.
1. Line im properly routed
in head.
2. Line im properly
wound into spool.
3. Inco rrect line size
4. Not enough line
outside of head.
5. Dirt buildup on unit.
1. Cr owding trimmer line
against material being
cut.
2. Electrical failure.
3. Thrown circuit breaker.
4. Debr is st opping head.
Line usage is
exce ssive.
1. Check line routing.
2. Replace spool.
3. Cut with tip of line fully extended.
4. Replace spool.
1. Line improperly routed
in head.
2. Line size is incorrect.
3. Cr owding line against
material being cut.
4. Spool worn or damaged.
W ARNING: Always stop unit and disconnect from the power source before per-
forming all of the r ecommended remedies below except remedies that require unit to
be operating.