Filter
Top Products
7
Theextensioncordusedtoreachthe
power sou rce must be:
D Specifically marked as suitable for out-
door u se. The cord m ust b e marked with
the suffix “W”.
D Heavy enough to carry full current from
the power source to the unit. Otherwise,
loss of power a nd overheating can occur
causing damage to unit. Refer to table for
minimum wire gauge recommendations.
The cord must be m arked with the proper
wire gauge. (Appropriate extension cords
are a vailable.) Do not use multip le cords.
D In good condition. Cord insulation must
be intact with no cracks or deterio ration.
Plug conn ectors must be undamaged.
DO NOT use multiple cords.
MINIMUM WIRE GAUGE
RECOMMENDATIONS
VOLTS
25 FT. 50 FT. 100 FT.
120 16
A.W.G.*
16
A.W.G.*
*American Wire Gauge
14
A.W.G.*
Secur e the ex t e nsion cor d to the uni t by
threa ding the co rd thro ugh the co rd re-
taine r (see illustratio n). Insert the cord
rece ptacl e int o the r ece ssed p l ug .
CAUTION: Failuretousecordretain-
er cou ld result in d amage to the unit,
extension cord, or both.
Cord
Retainer
Cord
Receptacle
Recessed
Plug
on Unit
USING YOUR UNIT
KNOW YOUR ELECT RIC BLOWER/VACUUM
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
UNIT.
Comp are the illustrations to yo ur unit to familia rize yourself with the location of
the various controls and adjustments. Sav e this manual for future reference.
Top Handle
Air Vents
ON
/
OFF Switch
Inlet Cover
Latch
Rear
Handle
Upper Vacuum Tube
Lower Va cuum Tube
Collection Bag
Blower Tube
Cord
Retainer
Inlet Restrict or
Vacuum As sist Handle
Tube Release Button
Elbow
Tube
Upper Va cuum Tube
Retaining Post
ON/OFF SWITCH
The
ON/OFF SWITCH is used to activate
the motor.
INLET COVER LATCH
The INLETCOVERLATCHis usedtoopen
and close the inlet cover and to secure
the upper v acu um tube to the blower
unit.