Filter
Top Products
7
Theextensioncordusedtoreachthe
power source must be:
D Specifically marked as suitable for out-
door u se. The cord must be marked w ith
the suffix “W”.
D Heavy enough to carry full current from
the power source to the unit. Otherwise,
loss of power and overheating can occur
causing damage to unit. Ref er to table for
minimum wire gauge recommendations.
The cord must be marked with the proper
wire gauge. (Appropriate extension cords
are a vailable.) Do not use m ultiple cords.
D In good condition. Cord insulation must
be intact with no cracks or deterio ration.
Plug conn ectors must be undamaged.
DO NOT use multiple cords.
MINIMUM WIRE GAUGE
RECOMMENDATIONS
VOLTS
25 FT. 50 FT. 100 FT.
120 16
A.W.G.*
16
A.W.G.*
*American Wire Gauge
14
A.W.G.*
Secur e the ex t e nsion cor d to the uni t by
threa ding the co rd thro ugh the co rd re-
taine r (see illustratio n). Insert the cord
rece ptacl e int o the r ece ssed p l ug .
CAUTION: Failuretousecordretain-
er could result in d amage to the unit,
extension cord, or both.
Cord
Retainer
Cord
Receptacle
Recessed
Plug
on Unit
USING YOUR UNIT
KNOW YOUR ELECTRIC BLOWER/VACUUM
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
UNIT.
Comp are the illustrations to your unit to familiarize yourself with the loc ation of
the various controls and adjustments. Save this manual for future reference.
Top Handle
Air Vents
ON
/
OFF Switch
Inlet Cover
Latch
Rear
Handle
Upper Vacuum Tube
Lower Vacuum Tube
Collection Bag
Blower Tube
Cord
Retainer
Inlet Rest rictor
Vacuum Assist Handle
Tube Release Button
Elbow
Tube
Upper Vacuum Tube
Retaining Post
ON/OFF SWITCH
The
ON/OFF SWITCH is used to activate
the motor.
INLET COVER LATCH
The INLETCOVERLATCHis usedtoopen
and close the inlet c over and to secure
the upper vacuum tube to the blower
unit.