Filter
Top Products
7
Air intake screen
WARNING: Stop your unit before at-
temptingto cleanthe intakescreen. DONOT
USE GARDEN HOSE OR PRESSURE
WASHER TO CLEAN THIS UNIT!
S Clean the intake screen periodically with a
nylon brush.
CLEAN THE AIR FILTER
A dirty air filter decreases engine perfor-
mance and increases fuel consumption and
harmful emissions. Always clean withengine
stopped. Cleanfilterafterevery 5hours ofop-
eration.
1. Clean the air filter cover and the area
aroundthecovertopreventdirt fromfalling
into t hecarburetor chamberwhenthecov-
er is removed.
2. Remove parts as illustrated. It is not nec-
essary to rem ove t he air filter hose from
the air filter cover.
NOTE: If the air filter hose becomes unat-
tached from the cover or lower handle during
cleaning,reattach beforeattemptingtorestart
the engine or operate the unit.
A
ir Filter Co
v
er
Air
Filter
Screws
Air Filter
Hose
NOTE: Do not clean filter ingasoline or ot h-
er flammable solvent to avoid creating a fire
hazard or producing harmful evaporative
emissions.
3. Wash the filter in soap and water.
4. Allow filter to dry.
5. Add 10 -- 15 drops of oil to the filter;
squeeze the filter to distribute oil.
NOTE: FILTER MUST BE OILED!
6. Replace parts.
REPLACE SPARK PLUG
Replace the spark plug each year to ensure
the engine starts ea sier and runs better. Set
spark pluggap at0.025 inch.Ignition timingis
fixed and nonadjustable.
1. Twist, then pull off spark plug boot.
2. Remove spark plug from cylinder and dis-
card .
3. Replace with Champion RCJ-6Y spark plug
and tighten securely with a 3 /4 inch socket
wrench.
4. Reinstall the spark p lug boot.
SERVICE AND ADJUSTMENTS
REPLACING THE LINE
For unit to operate properly, the cutting line
should be replaced when line becomes worn to
less than 3 inches in length from the edge of the
lineexit tunnels oneach side o f t he cutting head.
WARNING: Only replace cutting line
with engine switch in the OFF position.
1. Remove and discard worn line before
installing new line.
2. Use only 0.115″ (3 mm) diameter WEED
EA TER brand cut length line.
3. Insert one endof the linethrough theposi-
tioning tunnel.
4. Continue to feed line thr ough tunnel until
lineis centered (leavingequal amounts o n
each side). See illustration below.
Positioning
tunnel
5. Insertends oflineoneatatime t hroughthe
line exit tunnels.
6. Pull the line and make sure the line is ex-
tended fully through the tunnels.
Line exit
tunnels
7. Correctly installed line will be the same
length on both ends.
CARBURETOR ADJUSTMENTS
WARNING: Keep others away when
making idle speed adjustments. The trimmer
head will be spinning during most of this pro-
cedure. Wear your protective equipm entand
observe all safety precautions. After making
adjustments, the trimmer head must not
move/spin at idle speed.
The carburetor has been carefully set at the
factory.Adjustments m aybenecessary ifyou
notice any of the following conditions:
S Engine will not idle when the throttle is re-
leased.
S The trimmer head moves/spins at idle.