Filter
Top Products
7
TROUBLE CAUSE REMEDY
Semi-automatic
head stops
under a load or
does not turn
when switch is
pressed.
1. Allow tip of line to do the cutting.
2. Contact your authorized service dea ler .
3. Check B reaker B ox.
4. Remove debris.
Line does not
advance or
breaks w hile
cutting.
1. Check line routing.
2. Rewind line tightly and evenly.
3. Use only .065 i n. (1.65mm) dia. l ine.
4. Remove cover and pull 4 in.
(10 c m) of line out of head.
5. Clean unit .
Line welds onto
spool.
1. Use only .065 in. (1.65mm) dia. lin e.
2. Replace with correct spool.
3. Cut with tip of line fully extended.
Line releases
continuously .
1. Check line routing.
2. Replace spool.
Line pulls back
into head.
1. Too litt le line outside
of head.
2. Line size incorrect.
1. Remove cover and pull 4 i n .
(10 cm ) of line outside of head.
2. Use only .065 in. (1.65 mm) di a. line.
TROUBLESHOOTING TABLE
1. Line improperly
routed in head.
2. Spool damaged.
1. Line size is incorrect.
2. Incorrect spool.
3. Line is being crowded
against material being
cut.
1. Line improperly r outed
in head.
2. Line improperly
wound onto spo ol.
3. Incorrect line size
4. Not enough line
outside of head.
5. Dirt buildup on unit.
1. Crowding trimmer line
against m aterial being
cut.
2. Electrical f ailure.
3. Thrown circuit breaker.
4. Debris stopping head.
Line us age is
excessive.
1. Check line routing.
2. Replace spool.
3. Cut with tip of line fully extended.
4. Replace spool.
1. Line improperly r outed
in head.
2. Line size is incorrect.
3. Crowding line against
material being cut.
4. Spool w orn or damaged.
WARNING: Alwaysstopunitanddisconnectfromthepower sourcebefore
performingallof therecommended remediesbelowexceptremediesthatre-
quire operation of the unit.