Filter
Top Products
5
NOTE:
Remove the blade and metal shield
before attaching the plastic shield and trim-
mer head. To remove blade, push in locking
lever andhold. Rotate blade nutuntil thelock-
ing lever falls into one of the grooves in the
dust cup. Continue to hold the locking lever.
This will keep the shaft from turning while
loosening the blade nut. Remove blade nut
by turning clockwise. Release locking lever.
Remove both washers and blade. To remove
metal shield, loosen and remove the four
mounting screws. See ATTACHING THE
METAL SHIELD and INSTALLATION OF
THEMETALBLADE forillustrations. Be sure
to store all parts and instructions for future use.
ATTACHING THE PLASTIC SHIELD
AND TRIMMER HEAD
WARNING:
The shield mustbeprop-
erly installed. The shield provides partial
protection to the operator andothers fromthe
risk of thrown objects, and is equipped with a
line limiter blade which cuts excess line tothe
proper length. The l ine limiter blade (on un-
derside of shield) is sharp and can cut you.
1. Remove wing nut from shield.
2. Insert bracket into slot on shield.
3. Pivot shield until bolt passes through hole
in bracket.
4. Tighten the wing nut securely.
NOTE:
If yourunit hasa p lasticcoveroverthe
threads on the threaded shaft, remove the cov-
ering to expose the threads. Before installing
the trimmer head, make sure the dust cup is
positioned on the gearbox as shown below.
Wing Nut
Dust Cup
Bracket
Slot
Shield
Gearbox
NOTE:
Make sure all parts are properly
installed as s hown in the illustration before
installing the trimmer head.
5. Push in locking lever and hold.
6. Rotate dust cup until the locking lever
falls into one of the grooves
.
Locking Lever
7. Continue to hold inlocking lever. This will
keep the shaft from turning while tighten-
ing the trimmer head.
8. Threadtrimmer head onto the shaft inthe
direction shown onthe decal. Tighten un-
til secure.
9. Release locking lever.
ASSEMBLY INFORMATION -- WEED
BLADE
WEED
BLADE
NOTE:
Remove the trimmer head and plas-
tic shield before attaching the metal shield
and installing one of the weed blades. To re-
move the trimmer head, push in locking lever
and hold. Rotate trimmer head until the lock-
ing lever falls into one of the grooves in the
dust cup. Continue to hold in locking lever.
This will keep the shaft from turning while
loosening the cutting head. To remove the
plastic shield, loosen and remove wing nut.
Pivot shield to release bracket from slot. See
INSTALLATION OF THE CUTTING HEAD
and ATTACHING THE PLASTIC SHIELD for
illustrations. Be sure to store all parts and in-
structions for future use. Never use the trim-
mer head with the metal blade installed.
ATTACHING THE METAL SHIELD
WARNING:
The metal shield must
be properly installed on the tool any time the
tool is usedwithablade. The forwardtip ofthe
metal shield helps to reduce the occurrence
of blade thrust which can cause seriousinjury
such as amputation to the operator or by-
standers. Failure to install the shield in the
position shown can result in serious injury to
the operator. The length of the shield must be
aligned with the length of the tube.
1. Place the metal shield under the gearbox,
and align the screw holes.
Shield
Gearbox
2. Insert and thread the 4 mounting screws
through the holes of the gearbox and the
metal shield. Tighten evenly and secure-
ly with the hex wrench provided.