Filter
Top Products
5
ASSEMBLY
WARNING:
If received assembled,
repeat all steps to ensure your unit is properly
assembled and all fasteners are secure.
Examine parts for damage. Do not use dam-
aged parts.
NOTE:
If you need assistance or find parts
missing or damaged, call 1-800-554-6723.
TOOLS REQUIRED
S
Hex wrench (provided)
HANDLEBAR ASSEMBLY
DANGER:
RISK OF CUT. To avoid
serious injury, the barrier portion of the han-
dlebar must be installed as shown on the up-
per tube ofthe powerhead to provide abarrier
between operator and the spinning blade. At-
tach tube clamp above arrow on safety warn-
ing decal on the upper tube (powerhead end
of unit). Ensure handlebar is positioned on
handlebar clamp between the arrows on the
handlebar decal.
NOTE:
The tube clamp base has four
spacer tabs attached. These tabs are pro-
vided to adapt this attachment for use with
powerheads that have a 1
"
diameter upper
tube (the tube clamp will not tighten down se-
curely on the 1
"
diameter upper tube without
using these spacer tabs). The tabs must be
broken off completely before use and placed
over the screw holes on the clamp base.
These tabs are not needed f or powerheads
with a 7/8
"
upper tube.
Spacer Tabs
HANDLEBAR CLAMP BASE
Spacer Tabs
positioned for use
on 1
"
diameter
upper tube
1. Place the tube clamp over the upper tube
above the arrow on the safety decal.
2. Position the clamp base under the upper
tube and align the tube clamp and clamp
base screw holes (use spacer tabs be-
tween tube clamp and clamp base if nec-
essary to secure clamp, i.e. for 1
"
diame-
ter upper tube).
POWERHEAD
END
ATTACHMENT
END
Screws
Clamp
Base
Handlebar Clamp
between arrows on
handlebar decal
Clamp
Knob
Tube
Clamp
Handlebar
Arrow on
Safety Decal
3. Insert the four screws into the screw
holes.
4. Secure tube clamp by tightening screws
with the hex wrench.
5. Position the handlebar as shown, ensur-
ing the handlebar is positioned on the han-
dlebar clamp between the arrows on the
handlebar decal.
6. Retighten handlebar by turning clamp
knob clockwise until handlebar is secure
and stationary in clamp (clamp knob can-
not be overtightened).