Filter
Top Products
5
OPERATION
KNOW YOUR TRIMMER
READTHIS INSTRUCTIONMANUALANDSAFETYRULESBEFOREOPERATINGYOURUNIT.
Compare the illustrationswith your unit tofamiliarize yourself with thelocation of thevarious controls
and adjustments. Save this manual for future reference.
Cord
Retainer
Recessed
Clamp
Plug
Trigger Switch
Assist Handle
Twist and Edge Button
Motor Housing
Edge Guide
Line Limiter Blade
Trimmer Head
with 0.065 inch
Trimmer Line
Debris Shield
Air
Vents
Locking
Sleeve
Assembly
RECESSED PLUG
The RECESSED PLUG is where you attach
your extension cord to the unit.
TRIGGER SWITCH
TheTRIGGERSWITCHisusedtoturnonthe
unit.Squeezethetriggerswitchtooperatethe
unit. Release to stop.
LINE LIMITER BLADE
The LINE LIMITER BLADE cuts the cutting
line to the proper cutting length.
ASSIST HANDLE
The ASSIST HANDLE is used to help hold
and guide the unit.
TRIMMER HEAD
The TRIMMER HEAD holds the cutting line
and rotates during operation.
TWIST AND E DGE BUTTON
The TWIST AND EDGE BUTTON is used to
twist the lower portion of the unit into an edg-
ing position.
EDGE GUIDE
TheEDGEGUIDEprotects theunitfromcon-
tacting the ground during edging.
2. Insert the shield onto the motor housing.
Ensure the cutting head remains free to
rotate and the line is not caught between
the shield and the motor housing (see
following illustration).
3. Twisttheshieldas illustrateduntil the hole
in the shield aligns with the hole in the
housings. Make suretheshield is
4. Install bolt into shield and motor hous-
ing as shown. Tighten securely.
assembled to the unit as shown in the
following illustration and in the KNOW
YOUR UNIT section of this manual.
CAUTION: Sharp line limiter blade
Holes
Twist shield in this
direction to assemble
Bolt
Edge Guide
Shield