Walker MC (16 HP) Lawn Mower User Manual


 
4
ITEM PART DESCRIP TION NO.
NO. NO. REQ’D
ITEM PART DESCRIP TION NO.
NO. NO. REQ’D
Use only genuine Walker
®
replacement parts. Effective Date 12-01-00
BODY / CHASSIS ASSEMBLY (GHS MODELS)
Seat Assembly
1 5103 Seat 1
2 7203 Seat Spring Plate 1
3 7223 Compression Spring (1/2 x 1) 2
4 7845 Rubber Bumper (1.375 OD x .63) 2
5 7846 Rubber Washer (3/8 ID x 1-1/4 OD x 1/8) 2
6 7204 Shoulder Bolt, Seat Mount 2
7 7440-5 Shock Mount (1.25 D x .75) 2
Rear Bumper Assembly (GHS 6.7 Bushel Models Only)
*
8 5566 Tilt Stop Strap 1
9 5516 Rear Bumper (6.7) 1
10 7516-5 Catcher Pivot Bushing 2
11 5162 Roller Wheel (5") 2
12 7517-2 Catcher Pivot Plate 2
Body Assembly
13 6100-7 Welded Body 1
14 5989-3 Dome Plug (5/16) 2
15 5989-4 Dome Plug (3/8) 2
16 7146 13mm Ball Stud 2
17 5145 Gas Spring Assembly 1
(Includes Items # 16 & 18)
18 7147 Spring Clip 2
19 5180 Edge Molding, Lever Opening 2
20 5989-5 Dome Plug (7/16) 1
21 NS Body ID Plate 1
Tilt-Up Latch Assembly
22 5847 Plastic Tip 1
23 5744-20 Tilt-Up Latch Spring Arm 1
24 5744-10 Spring Pivot Bushing 1
25 5744-15 Compression Spring (3/8 x 5/8) 1
26 5744-13 Mount Angle, LH 1
27 5744-12 Hook, Tilt-Up Latch 1
28 5744-14 Mount Angle, RH 1
Chassis Assembly
29 5845 Rubber Bumper (1.50 OD x 1.25) 2
30 5267-1 Retainer Collar (1") 1
(Includes Item # F113)
31 5270-1 Pivot Bearing 2
32 5420-2 Tail Wheel Fork 1
33 5037-1 Bearing 2
34 5035 Tail Wheel & Tire Assembly (13 x 6.50-6) 1
5035-1 Tire Only (13 x 6.50-6)
**
5036 Wheel & Hub Only (6 x 4.5)
**
35 5038-1 Axle Spacer Tube (6-5/8) 1
36 5075 Wheel & Tire Assembly LP (18 x 8.50-10) 2
5070-2 Tire Only (18 x 8.50-8)
**
5070-4 Wheel Only (8 x 7)
**
5033-2 Wheel & Tire Assembly (18 x 6.50-8)
***
5030-2 Tire Only (18 x 6.50-8)
**
5031-2 Wheel Only (8 x 5.5)
**
5030-4 Tire Tube (18 x 8.50-8)
**
37 6307-1 Chassis Frame 1
Fasteners
F002 10-24 Keps Nut 2
F004 1/4-20 Keps Nut 2
F009 5/16-18 Whiz Locknut 10
F012 3/8-16 Keps Nut 2
F013 3/8-16 Whiz Locknut 2
F014 3/8-16 ESNA Nut 4
F016 1/2-13 Self-Locking Nut 1
F020 5/16-18 ESNA Nut 1
F026 10-24 x 1/2 PPHMS 1
F027 10-24 x 5/8 PPHMS 1
F029 1/4-20 x 1/2 Hex Bolt 2
F034 5/16-18 x 3/4 Hex Bolt 4
F040 3/8-16 x 1-1/2 Hex Bolt 2
F042 3/8-16 x 2 1/4 Hex Bolt 2
F048 1/2 SAE Washer 2
F051 3/8 SAE Washer 2
F059 3/8 Wave Spring Washer 2
F085 3/16 Rivet Backup Washer 1
F087 #10 x 7/8 Fender Washer 2
F093 5/16-18 x 1 Hex Bolt 1
F113 5/16-18 x 5/16 Set Screw 2
F151 3/8-16 x 7/8 Hex Bolt 2
F157 1/2-20 x 1-1/4 Wheel Lug Bolt 8
F206 #2 x 3/16 Drive Pin 2
F227 3/8 x 1-1/4 x 1/8 Plastic Washer 2
F241 .375 x .875 x .10 Washer 4
F292 1/2-13 x 8-1/2 Hex Bolt GR 2 1
F341 Coil Roll Pin (7/64 x 9/16) 1
F342 5/16 Conical Washer 2
*
Rear Bumper Assembly for GHS 9.5 Bushel Models is not
shown here. Refer to BODY ASSEMBLY (GHS 9.5 BUSHEL
MODELS), Page 6. Rear Bumper Assembly for SD Models is
not shown here. Refer to BODY ASSEMBLY (SD MODELS),
Page 8.
**
Service Part Only
***
May be ordered as a factory-installed option or for dealer
installation. Narrow Drive Tires are used when installing a 36"
Deck. Contact your Walker dealer.