Filter
Top Products
— 5 —
The skillet must be installed so that the flow of combustion and ventilation air will not be obstructed.
Adequate clearance for air openings into the combustion chamber must be provided. Make sure there
is an adequate supply of air in the room to allow for that required for combustion of gas at the burners.
Do not permit fans to blow directly at the skillet. Wherever possible, avoid open windows next to the
skillet. Avoid wall-type fans which create air across currents within the room.
INSTALLATION CODES AND STANDARDS
The Vulcan tilting skillet must be installed in accordance with:
In the United States of America:
1. State and local codes.
2. National Fuel Gas Code, ANSI-Z223.1 (latest edition). Copies may be obtained from The American
Gas Association, Inc., 1515 Wilson Blvd., Arlington, VA 22209.
3. National Electrical Code, ANSI/NFPA-70 (latest edition). Copies may be obtained from The
National Fire Protection Association, Batterymarch Park, Quincy, MA 02269.
In Canada:
1. Local codes.
2. CAN/CGA-B149.1 Natural Gas Installation Code (latest edition).
3. CAN/CGA-B149.2 Propane Installation Code (latest edition), available from the Canadian Gas
Association, 178 Rexdale Blvd., Etobicoke, Ontario, Canada M9W 1R3.
4. Canadian Electrical Code, CSA C22.2 No. 3 (latest edition). Copies may be obtained from The
Canadian Standard Association, 178 Rexdale Blvd., Etobicoke, Ontario, Canada M9W 1R3.
LEVELING AND ANCHORING TILTING SKILLET
The tilting skillet must be anchored to the floor.
1. Place skillet in the installation position.
2. Place a carpenter's level on top of the skillet and turn the adjustable feet to level the skillet side to
side and front to back.
3. Mark hole locations on the floor through the anchoring holes provided in the rear flanged adjustable
feet. See diagram on page 7.
4. Remove skillet from installation position and drill holes in locations marked on the floor. Insert
proper anchoring devices (not supplied).
5. Place skillet back in the installation position.