Filter
Top Products
8 English
Getting Started
Using your Vornado Heater is easy. Just follow these simple steps.
1. Position your heater so the vortex beam of warm air is directed
across the room unobstructed. Position it in a location that is
representative of the room temperature. The unique side-angled air
inlets allow the heater to be placed closer to walls than possible with most
ordinary heaters (but do not place close to combustibles). Avoid areas of
temperature extremes such as cold drafts and heat registers (refer
to IMPORTANT INSTRUCTIONS for safe placement).
2. Plug power cord into a standard wall outlet.
3. Press the Power switch On.
4. Select Low, Medium or High heat.
5. Set thermostat to the highest setting. When the room reaches
the desired comfort level, turn the thermostat knob slowly
counterclockwise until the heat cycles off.
How To Use
Resetting Your Vornado Heater
Your Vornado Heater has a multi-level safety shut-off system
designed to prevent overheating. Overheating may occur when
the inlets or outlet are blocked, a foreign object prevents the
blade from turning, or the appliance tips over. If this happens,
the safety shut-off system will cut power to the heat element
and you will need to manually reset the heater.
1. Turn the Power switch Off and unplug the unit.
2. Remove any obstructions.
3. Wait 5–10 minutes, allowing the unit to cool down.
4. Plug in the unit and place in desired position.
5. Turn the Power switch On. Your Vornado Heater should now
function normally.
Note: If the safety shut-off system repeatedly shuts off
your heater or if it will not reset after following the above
procedure, DO NOT ATTEMPT TO DISASSEMBLE THE
UNIT. Call Vornado Consumer Services Department toll-free
at 1-800-234-0604.