Filter
Top Products
11
English
To properly carry the heater, place one hand on the back opening
and use your other hand to hold from the front.
In smaller areas, you might prefer to set the unit in Low mode. A
vortex beam of air will gently keep the air circulating in the room for
even, uniform heating.
In larger spaces, you might prefer to set the unit in High mode. A
vortex beam of air will gently keep the air circulating in the room for
even, uniform heating.
The MVH, like any other 1500-watt electric heater, draws up to
12.5 amps of electric current. If using your MVH on High setting
causes your home circuit breaker or fuse to trip, we offer the
following suggestions:
Try turning off other electrical appliances that run on the same
circuit as your heater.
Run your heater in Low mode.
Have your electrician add an additional circuit to your home’s
electrical system.
When the room temperature is higher than the set temperature it is
normal and correct to have little to no heat coming out of the MVH.
When the unit is first turned on there is a slight delay before heat
will start to be produced.
ALWAYS USE COMMON SENSE WHEN USING THIS AND/OR ANY
ELECTRICAL APPLIANCE.
Do not use more than one heater at a time.
Never ignore or take lightly the signs of an electrical problem, such
as:
Warm outlet cover plates
Sparking at outlet when plugging in or during operation
Light flickering or dimming (indicates a shared circuit or problem)
Investigate the cause of these before continuing to use the heater.
Operating Tips