Filter
Top Products
xStream Duo Pro only THERAPY OPERATING INSTRUCTIONS
The xStream Duo Pro spa has been designed for your
maximum enjoyment and comfort, with two totally
independent areas, one for swimming exercises and
one for therapy.
It has also been engineered for energy efficiency. The
two areas run independently by two separate ICS
TM
electronic control centers that allow each area to have
their temperatures and filtration cycles individually
controlled.
With the ICS
TM
electronic control center you may
program for each and every day of the week different
temperatures and filtration cycles, giving you all the
tools for maximum energy savings.
INITIAL START UP
Your spa has been programmed for your convenience.
Once properly connected, the pump and heater will
automatically come on and heat the therapy to 102ºF
(39ºC). Date and time must be set at this time by
following the Therapy Programming Instructions, which
also allow all other spa features to be programmed.
The L60 Control Center controls each function directly
with a dedicated button. A brief description of each
button is as follows:
By pressing this button the pump cycles
through a soothing “soaking” mode, to an
invigorating “therapy” mode and then off.
Note: If the spa is in the programmed
filtration cycle or in heating mode, it will
immediately restart running at low speed to
filtrate and/or heat the water.
This button controls the LED lights. The first
press turns the underwater light on. Second
press turns the waterfall light on. Third press
turns lights off. For color and intensity
programming, please refer to the Aquabrite/
Chromatherapy instructions on page 12.
This button is used to cycle between time
and temperature display and also to enter
and process programming functions.
This button increases the value on display.
This button decreases the value on display.
This button is not active on this model.
DISPLAYING TIME OR TEMPERATURE
Press to switch the display between current time
and current water temperature.
SETTING THE TEMPERATURE FOR A DAY
Press to display water temperature.
Press to increase the set temperature.
Press to lower the set temperature.
NOTE:
This setting only alters the temperature for the
rest of the day.
Go to section “E. HEAT DAYS & TEMPERATURE”
on page 8 to make permanent changes.
IMPORTANT:
When your spa is activated or temperature is
adjusted, the spa goes through a 2-½ minute
calibration cycle. The controller will evaluate the
temperatures at the heater and water in the spa
and will determine proper operation and heating
needs. The calibration process is indicated by the
flashing of the heater LED on the L60 Control Center
display.
xStream Duo Pro
Therapy Control Center
Operates functions on therapy portion of Duo Pro
PAGE 6