Filter
Top Products
20
©
2006 Directed Electronics—all rights reserved
If your remote transmitter is lost or damaged, you can manually
override the starter kill. To do this, you must have the vehicle's
ignition key and know where the Valet switch is located. Be sure
to check with the installer for the location of the Valet switch.
To override the starter kill, turn
the ignition on and press the
Valet switch within 10 seconds.
The status LED will stop flashing
and the vehicle should start. If it does not start, you may have
waited too long; turn the ignition off and repeat the process.
LOCATION OF VALET SWITCH_____________________________
You can prevent your system from automatically activating the
Failsafe
®
Starter Kill and locking the doors by using Valet Mode.
This is very useful when washing the vehicle or having it serviced.
In Valet Mode, the starter kill cannot be activated, even with the
transmitter, but all convenience functions (door locks, remote
start, etc.) will continue to work normally.
Valet Mode
DRW-35
Disabling the Starter Kill Without a Transmitter