Troy-Bilt TB5018CC, TB5020CC Chainsaw User Manual


 
10
STARTING/STOPPING INSTRUCTIONS
Operate this unit only
in a well- ventilated
outdoor area. Carbon monoxide exhaust
fumes can be lethal in a confined area.
WARNING:
Never operate the saw
without the bar and
chain properly installed.
WARNING:
1. Slide the STOP switch down (Fig. 2).
2. Rotate the choke lever up to the horizontal
position (Fig. 3).
3. Pump primer bulb 10 times (Fig. 4).
4. Pull starter rope 4-6 times, engine should
start (Fig. 5).
5. If engine failed to start, rotate choke lever down to
vertical position then repeat step 4 (Fig. 5).
6. When engine starts, warm up 10 sec.
Then depress safety/throttle trigger.The automatic
choke will disengage when trigger is pulled (Fig.6).
7. Release throttle trigger for idle.
TO STOP: Slide stop switch up.
NOTE: This unit will not run with the choke lever in
horizontal Position 1.
NOTE: The unit uses Spring Assist Starting™, which
significantly reduces the effort required to start the
engine. You must pull the starter rope out far
enough to hear the engine attempt to start. There
is no need to pull the rope briskly-- there is no
harsh resistance when pulling. Be aware that this
starting method is vastly different from (and much
easier than) what you may be used to.
STARTING INSTRUCTIONS
F
Fig. 6
Fig. 5
Fig. 4
Fig. 3
Fig. 2
D
Fig. 1
A
B
C
Horizontal position
Vertical position
A
B
Automatic