Troy-Bilt TB2246 Lawn Mower User Manual


 
Problem Cause Remedy
Engine fails to start 
2.
Spark plug wire disconnected. 3.
Throttle/Choke control lever not in correct 
starting position.
Fuel tank empty, or stale fuel. 5.
Blocked fuel line. 
Faulty spark plug. 7.
Engine flooded. 8.

Engage parking brake. 2.
Connect wire to spark plug. 3.
 
Fill tank with clean, fresh (less than 30 days 5.
old) gas.
Clean fuel line and replace fuel filter. 
Clean, adjust gap or replace plug. 7.
Crank engine with throttle in FAST position. 8.
Engine runs erratic Tractor running with Choke activated. 
Spark plug wires loose. 2.
Blocked fuel line or stale fuel. 3.
Vent in gas cap plugged. 
Water or dirt in fuel system. 5.
Dirty air cleaner. 
Move the Throttle/Choke control lever out of 
the choke position.
Connect and tighten spark plug wires. 2.
Clean fuel line; fill tank with clean, fresh 3.
gasoline and replace fuel filter.
Clear vent or replace cap if damaged. 
Drain fuel tank. Refill with clean, fresh 5.
gasoline.
Replace air cleaner paper element or clean 
foam precleaner.
Engine overheats Engine oil level low. 
Air flow restricted. 2.
Fill crankcase with proper amount and 
weight of oil.
Clean grass clippings and debris from around 2.

Engine hesitates at high

Spark plug gap too close.  Remove spark plug and reset the gap. 
Engine Idles rough Spark plug fouled, faulty or gap too wide. 
Dirty air cleaner. 2.
Replace spark plug. Set plug gap. 
Replace air cleaner element and/or clean 2.
pre-cleaner.
Excessive vibration Cutting blade loose or unbalanced. 
Damaged or bent cutting blade. 2.
Tighten blade and spindle. 
Replace blade. 2.
Mower will not mulch grass Engine speed too low. 
Wet grass. 2.
Excessively high grass. 3.
Dull blade. 

position.
Do not mulch when grass is wet. 2.
Mow once at a high cutting height, then 3.
mow again at desired height or make a
narrower cutting swath.
Sharpen or replace blade. 
Uneven cut Deck not leveled properly. 
Dull blade. 2.
Uneven tire pressure. 3.

Sharpen or replace blade. 2.
Check tire pressure in all four tires. 3.
Troubleshooting
8
29