Troy-Bilt TB210 Lawn Mower User Manual


 
16 se c t i O n 6— Ma i n t e n a n c e & ad j u s t M e n t s
Engine Care
A list of key engine maintenance jobs required for good
performance by the mower is given below. Follow the
accompanying engine manual for a detailed list and instructions.
Maintain oil level as instructed in engine manual.
Service air cleaner every 25 hours under normal conditions. 
Clean every few hours under extremely dusty conditions.

that the air cleaner should be serviced. To service the air
cleaner, refer to the engine manual.
Clean spark plug and reset the gap once a season. Spark 
plug replacement is recommended at the start of each
mowing season. Check engine manual for correct plug
type and gap specifications.
Clean engine regularly with a cloth or brush. Keep the 
top of the engine clean to permit proper air circulation.
Remove all grass, dirt, and combustible debris from muffler
area.
Deck Wash (If Equipped)

surface as part of its deck wash system.

underside and prevent the buildup of corrosive chemicals.


enough for your garden hose to reach.

chute is directed AWAY from your house, garage,
parked cars, etc.
2.

3.

Turn the water on.
5.
Run the engine for a minimum of two minutes, allowing the 
underside of the cutting deck to thoroughly rinse.
Release blade control to stop the engine and blade.7.
Turn the water off and detach the hose coupler from the water 8.

After cleaning your deck, restart the mower. Keep the engine
and blade running for a minimum of two minutes, allowing the
underside of the cutting deck to thoroughly dry.
