Troy-Bilt TB210 Lawn Mower User Manual


 
10 se c t i O n 3 — as s e M b l y & se t-up
C
C
A
B
B
D
A
B
C
The rope guide is attached to the right side of the upper 
handle. Loosen the wing knob which secures the rope

a.
Slowly pull starter rope handle from engine and slip b.

Tighten rope guide wing knob.c.
Use cable tie(s) to secure cable(s) to lower handle.d.
Grass Catcher
Follow steps below to assemble the grass catcher (if 
needed). Make certain bag is turned right side out before
assembling (warning label will be on the outside).
a.
at the bottom.
Remove the T-bolts from the handle brackets as shown in 2.
Fig. 3-3.
Follow the steps below to complete handle assembly:3.
a.
handle (shown in Fig. 3-3 deck cutaway) line up with

NOTE: When pulling upward on handle, make sure to not
pull handle all the way out.
Insert the T-bolts removed earlier through the b.
handle brackets and lower handle and tighten

Reattach wing nuts and carriage bolts removed c.
earlier into lower holes of handle as shown in Fig.
3-5.



