Filter
Top Products
Controls & Features
4
13
Deck Wash
Your mower’s deck may be equipped with a water port on its
surface as part of its deck wash system. Use the deck wash to
rinse grass clippings from the deck’s underside.
Side Discharge Chute
Your mower is shipped as a mulcher. To discharge the grass
clippings to the side instead, follow the instructions in the
“Assembly & Set-Up” section to attach the side discharge chute.
WARNING: Keep hands and feet away from the
chute area on cutting deck. Refer to warning label
on the unit.
Recoil Starter
The recoil starter is attached to the right upper handle. Stand
behind the unit and pull the recoil starter rope to start the unit.
Electric Starter Button (If Equipped)
The electric starter button is located on the right side of the
upper handle. It is used only for the electric starter.
Blade Control
The blade control is attached to the upper handle of the mower.
Depress and squeeze it against the upper handle to operate the
unit. Release it to stop engine and blade.
WARNING: This blade control is a safety device.
Never attempt to bypass its operations.
Drive Control
The drive control is located on the underside of the upper handle
and is used to engage the drive. Squeeze it against the upper
handle to engage the drive; release it to slow down or stop
mower from propelling.
Cutting Height Adjustment Lever
One adjustment lever is located on the right rear wheel and one
is located on the right front wheel. Both levers have to be at the
same relative position to ensure a uniform cut. To adjust the
cutting height, refer to the “Assembly & Set-Up” Section.
Blade Control
Recoil Starter
Cutting Height
Adjustment Lever
Cutting Height
Adjustment
Lever
Side Discharge
Chute
Drive Control
Mulch Plug
Grass Catcher
Deck Wash
Figure 4-1