Troy-Bilt TB1942 Lawn Mower User Manual


  Open as PDF
of 36
 
Deck Lift Lever

the deck lift lever is used to change
the height of the cutting deck. To
use, move the lever to the left, then
place in the notch best suited for
your application.
Ignition Switch Module
WARNING! Never
leave a running
machine unattended.
Always disengage

brake, stop engine
and remove key to
prevent unintended
starting.
To start the engine, insert the key
into the ignition switch and turn
clockwise to the START position.
Release the key into the  position once
the engine has fired.
To stop the engine, turn the ignition key counterclockwise to the

CAUTION: Prior to operating the tractor, refer to
both Safety Interlock Switches and Starting The

detailed instructions regarding the Ignition Switch
Module and operating the tractor in REVERSE
.
Drive Pedal
The drive pedal is located on the right side
of the tractor, along the running board. Press
the drive pedal forward to cause the tractor to
travel forward. Ground speed is also controlled
with the drive pedal. The further forward that
the pedal is pivoted, the faster the tractor
will travel. The pedal will return to its original

Reverse Pedal
The reverse pedal is located on the right side of
the tractor along the running board. Ground
speed is also controlled with the reverse pedal.
The further downward the pedal is pivoted,
the faster the tractor will travel. The pedal will

pressed.
LCD Service Minder & Hour Meter
When the ignition key is rotated

into the START position, the LCD
Service Minder and Hour Meter
will briefly display the battery

accumulated hours.
NOTE: Hours of tractor
operation are recorded any time
the ignition key is rotated out of

whether the engine is started.
The LCD Service Minder will remind the operator of maintenance
intervals for changing the engine oil, air filter service, low engine
and low battery warnings.
Change Oil



on the display for 7 minutes after the meter reaches 50 hours.
This oil service minder interval will occur every 50 hours. Before
the interval expires, change the engine oil as instructed in the

Low Oil


oil. Stop the tractor immediately and check the engine oil level as

Low Battery
At startup, the battery voltage is briefly
displayed then changes to accumulated





generating sufficient amperage. Charge the battery as instructed
in the Service section of this manual or have the charging system
checked by your local service dealer.
Air Filter Service




display for 7 minutes after the meter reaches 25 hours. This air

intervals that are common with oil service, the oil message will
be displayed first followed by the air filter message.
13Section 4 — controlS and FeatureS
 previous next