Filter
Top Products
11
CHANGING THE OIL
For a new engine, change the oil after the first 10 hours of
operation. Change the oil while the engine is still warm. The oil will
flow freely and carry away more impurities.
1. Unplug spark plug wire to prevent accidental starting.
2. Remove the oil fill plug/dipstick.
3. Pour the oil out of the oil fill hole and into a container by
tipping the unit to a vertical position (Fig. 17). Allow ample
time for complete drainage.
Fig. 17
Fig. 16
NOTE: Make sure the O-ring is in place on the oil fill plug/dipstick
when checking and changing the oil (Fig. 16).
4. Wipe up any oil residue on the unit and clean up any oil
that may have spilled. Dispose of the oil according to
Federal, State and local regulations.
5. Refill the crankcase with 3.04 fluid ounce (90 ml) of SAE 30
SF, SG, SH oil.
NOTE: Use the bottle and spout saved from initial use to measure
the correct amount of oil. Pour fresh fuel into the bottle
and fill it to the top of the label. The top of the label on the
bottle measures approximately 3.04 ounces (90 ml).
Check the level with the dipstick. If the level is low, add a
small amount of oil and recheck. Do not overfill (Fig. 18).
6. Replace the oil fill plug/dipstick.
7. Reconnect the spark plug wire.
Fill Level
Fig. 18
Oil Fill Plug/Dipstick
Oil Fill Hole
O-Ring
MAINTENANCE AND REPAIR INSTRUCTIONS
CAUTION:
Wear gloves to prevent injury when
handling the unit.
AIR FILTER MAINTENANCE
Cleaning the Air Filter
Clean and re-oil the air filter every 10 hours of operation. It is
an important item to maintain. Failure to maintain your air filter
properly can result in poor performance or can cause
permanent damage to your engine.
1. Open the air filter cover. Push the tab on the left side of the
cover in, swing the air filter cover out and off the air filter
housing (Fig. 19).
2. Remove the air filter and the screen that sits behind it (Fig. 19).
Air Filter
Air Filter
Screen
Hooks
Slot
Choke Lever
Air Filter Cover
Air Filter Housing
Tab
Tab
Fig. 19
WARNING: To avoid serious personal injury,
always turn the unit off and allow it to cool before
you clean or service it.