Filter
Top Products
11
Change-over lever
OPERATING AS A BLOWER
Converting to a Blower
1. Start the unit. See Starting/Stopping Instructions.
2. Set the blower/vacuum mode change-over lever to
the up position (Blower Mode) (Fig. 14).
NOTE: Never use the unit with the lever in a position half
way between either mode.
3. If you are using the optional shoulder harness, place
it over your head and onto your shoulder and adjust
it before starting. Refer to Installing the Shoulder
Harness.
Fig. 14
Fig. 15
Fig. 16
Fig. 17
OPERATING INSTRUCTIONS
Blower Operating Procedures
Hold the blower as shown in Figures 15, 16 and 17.
Sweep from side to side with the nozzle several inches
above the ground or floor. Slowly advance the unit,
keeping the accumulated pile of debris in front of you.
Most dry blowing operations are better suited to low
speeds, rather than high. High speed blowing is a better
way to move heavier items like large debris or gravel.
1Use the blower for trees, shrubs, flower beds and
hard-to-clean areas (Fig. 15).
2. Use the unit around buildings and for other normal
cleaning procedures (Fig. 16).
3. Use the blower around walls, overhangs, fences and
screens (Fig. 17).
Vacuum
Mode
Blower
Mode