Filter
Top Products
9sectiOn 2 — asseMbly & set-up 9sectiOn 2 — asseMbly & set-up
Attaching The Steering Wheel
If the steering wheel for your tractor did not come attached, the
hardware for attaching it has been packed within the steering
wheel, beneath the steering wheel cap. Carefully pry off the
steering wheel cap and remove the hardware.
With the wheels of the tractor pointing straight forward,
place the steering wheel over the steering shaft.
Place the washer (with the cupped side down) over the
steering wheel and secure with the hex bolt. See Fig. 3-3.
Place the steering wheel cap over the center of the steering
wheel and push downward until it “clicks” into place
Attaching The Seat
If the seat for your tractor was not attached at the factory, refer
to the following steps.
NOTE: For shipping reasons, seats are either fastened to the
tractor seat’s pivot bracket with a plastic tie, or mounted
backward to the pivot bracket. In either case, free the seat from
its shipping position and remove the two knobs from the bottom
of seat before proceeding with the instructions below.
Position the shoulder screws (found on the base of the
seat) inside the slot openings in the seat pivot bracket.
Fig. 3-4.
Slide the seat slightly rearward in the seat pivot bracket,
lining up the rear slots in the pivot bracket with the
remaining two holes in the seat’s base.
Select desired position for the seat, and secure with the
two knobs removed earlier.
To adjust the position of the seat on models so equipped,
loosen the two knobs on the bottom of the seat. Slide the
seat forward or backward as desired. Retighten the two
knobs.
1.
2.
3.
1.
2.
3.
4.
Tire Pressure
WARNING! Maximum tire pressure under any
circumstances is 30 psi. Equal tire pressure should be
maintained at all times. Never exceed the maximum
inflation pressure shown on the sidewall of the tire.
The recommended operating tire pressure is:
Approximately 10 psi for the rear tires
Approximately 14 psi for the front tires
IMPORTANT: Refer to the tire sidewall for exact tire
manufacturer’s recommended or maximum psi. Do not
overinflate. Uneven tire pressure could cause the cutting deck to
mow unevenly.
Gas and Oil Fill-up
The gasoline tank is located under the hood and has a capacity
of 1 ⁄ gallons. Do not overfill.
WARNING! Use extreme care when handling
gasoline. Gasoline is extremely flammable and the
vapors are explosive. Never fuel machine indoors or
while the engine is hot or running. Extinguish
cigarettes, cigars, pipes, and other sources of ignition.
Service the engine with gasoline and oil as instructed in the
separate Engine Operator/Owner Manual packed with your
tractor. Read instructions carefully.
IMPORTANT: Your tractor is shipped with motor oil in the
engine. However, you MUST check the oil level before
operating. Be careful not to overfill.
•
•
Figure 3-3
Figure 3-4