Filter
Top Products
8SECTION 3— ASSEMBLY & SET-UP
Pull the beam lock outward, line it up with the hole in the C.
beam bracket and release the beam lock. See Fig 3-3.
Fasten the tongue tube to the frame by reinstalling the two D.
three-inch hex screws removed earlier and tightly securing
with the two flange lock nuts. See Fig. 3-3.
Positioning the Jack Stand
CAUTION: Do not attempt to move the logsplitter
off of the crate base until after the jack stand has
been positioned downward.
The jack stand is shipped in the transport position. It must be
repositioned prior to fully uncrating the logsplitter.
Remove the spring clip and clevis pin and pivot the jack 1.
stand toward the ground, into the operating position.
Secure the jack stand in position with the clevis pin and the 2.
spring clip. See. Fig. 3-4.
Removing the Supports
CAUTION: Do not attempt to move the logsplitter
off of the crate base until after the crate supports
and plastic tie-straps have been removed.
There are three tie-straps securing the logsplitter to the crate,
one on the beam support and one on each side of the reservoir
tank, near each fender. There are also two supports found on the
logsplitter crate, one beneath the engine and one beneath the
beam.
Carefully cut and discard each tie-strap and remove and discard
each support. See Fig 3-5.
Note: The jack stand, repositioned in the previous step, will
support the weight of the logsplitter with the supports removed.
Figure 3-3
Clevis Pin
Spring Clip
Figure 3-4
Figure 3-5