Filter
Top Products
Controls & Features
4
11
Log
Dislodger
Control
Handle
Log Tray
Vertical
Beam Lock
Dipstick
Horizontal
Beam Lock
Jack Stand
Hitch
Coupling
Figure 4-1
Engine Controls
See the Engine Operator’s Manual for the location and function
of the controls on the engine.
Beam Locks
The beam locks are used to secure the beam in either the
horizontal position or the vertical position. The vertical beam
lock is located next to the engine. The horizontal beam lock is
located on the beam support latch bracket.
Control Handle
Use the control handle to move the log splitter wedge forward
and backward along the beam. It has three positions; Forward,
Neutral and Reverse. See the Operation section for instructions.
Dipstick
Use the dipstick to check the hydraulic fluid level.
Log Dislodger
The log dislodger is designed to remove any partially split wood
from the wedge while it is retracting. This may occur while
splitting large diameter wood or freshly cut wood.
Log Tray
The log tray is designed to catch the log after it is split.
Hitch Coupling
Use the hitch coupling to attach the log splitter to a towing
vehicle for transportation.
Jack Stand
The jack stand supports the log splitter while in the operating
position.