Filter
Top Products
A
J
B
°-! °
Fig. 2-3: Wheel in FREEWHEELposition
STEP 4: INSTALL FORWARD
CLUTCH CABLE
1. Carefullyunwrapthe forward clutch ca-
ble(cablewithout an attachedknob) from
its shipping position and slide the thin ca-
blewire (T,Fig. 2-4) into the slot in the ca-
blebracket. Pushthe cable connector (U,
Fig.2-4) upthrough the holein thebracket
untilthe groove in the connector snaps
into place.
2. Threadthe#10-24 hexnut (Z, Fig. 2-5)
halfway ontothe screw (V) which runs
through the spring (W, Fig.2-5).
3. Threadthe screw (V) into the cable ad-
juster (X).
Fig. 2.2: Attachhandlebar.
drive pin (M) through thewheelshaft only
(not through the wheelhub). Secure the
wheeldrive pin with the hairpin cotter (L),
pushingthe hairpincotter in as faras it will
go. Thewheel should now spin freely
(freewheel) on the wheelshaft. Repeat
with the other wheel.
4. Usethe handlebarto roll the tiller to a
flat area.
IMPORTANT: Beforestartingthe engine,
the wheels must beplaced in theWHEEL
DRIVEposition (pins through wheelhubs
andwheelshaft). This procedure is
describedin WheelDrivePinsin Section3.
Fig. 2-4: Installingforwardclutchcablebracketand cable.