Filter
Top Products
Fig. 2=3:Wheelin FREEWHEELposition
STEP4: INSTALL FORWARD
CLUTCH CABLE
1. Attach theforward clutch cablebracket
(P,Fig.2-4) to the handlebarsupport AI
with a1/4"-20x 1-1/4"hexhd. screw (R)
and 1/4"-20hexIocknut (S).Tighten se-
curely.
2. Carefullyunwrapthe forward clutch ca-
ble (cablewithout anattached knob, from
its shipping position and slidethe thin ca-
ble wire (T,Fig.2-4) intothe slot inthe ca-
ble bracket. Pushthe cableconnector(U,
Fig.2-4) upthrough the holein thebracket
until the groove in the connector snaps
into place.
3. Insertthe #10-24 x 2" slotted hd.screw
(V,Fig.2-5) downthrough the hookedend
of the cablespring (W) until the screw
Fig.2.2:Atlachhandlebar(5.5 HpMOde!shown), threads extendthr0ugh the spring.
2. Removethe hairpin cotter (L, Fig.2-3)
and wheeldrive pin (M) from the wheel
hub (0) and wheelshaft (N).
3. Slidethe wheelfully inwardonthewheel
shaft (N, Fig.2-3). Reinstall the wheel
drive pin (M) through the wheelshaft only
(not through thewheel hub). Securethe
wheeldrive pin with the hairpin cotter (L),
pushingthe hairpincotter in asfar asit will
go. Thewheelshould now spin freely
(freewheel) on the wheelshaft. Repeat
with the other wheel.
4. Usethe handlebarto roll the tiller to a
flat area.
IMPORTANT:BeforeStartingtheengine,
thewheels must be placedin theWHEEL Fig.2-4.Installingforwardclutchcablebracketandcable.
DRIVEposition (pins through wheelhubs
andwheelshaft). Thisprocedureis
described in WheelDrive Pinsin Section3.