Troy-Bilt TB425CS Trimmer User Manual


 
7
ASSEMBLY INSTRUCTIONS
For TB475SS only: ADJUST THE D-HANDLE
The TB475SS uses a D-handle only, which is pre-
installed on the unit. If you ever need to adjust it, make
sure it is at least 6 inches from the end of the shaft grip
(Fig. 1).
2. While holding the three pieces together, install the four
(4) screws through the top clamp and into middle clamp.
NOTE: The holes in the top and middle clamp will line up
only when assembled correctly.
3. Place the clamps and the J-handle over the shaft
housing and onto the bottom clamp.
4. Hold each hex nut in the bottom clamp recess with a
finger. Start screws with a large Phillips screwdriver.
Do not tighten until you make the handle adjustment.
5. Slide the J-handle in or out until the arrow/white line on
the decal touches the clamp assembly (Fig. 3). You must
first loosen the screws if the handle is pre-installed.
Fig. 2
Fig. 3
6. While holding the unit in the operating position
(Fig. 27), position the J-handle to the location that
provides you the best grip.
7. Tighten the clamp screws evenly, until the J-handle
is secure.
For TB425CS only: INSTALL AND ADJUST
THE J-HANDLE
1. Place the J-handle between the top and middle
clamp pieces (Fig. 2).
Decal
(4) Screws
Top Clamp
J-Handle
Middle Clamp
Bottom Clamp
Nuts
Shaft
Housing
Bottom Clamp
Shaft Grip
Minimum 6 inches
(15.24 cm)
Fig. 1