Filter
Top Products
6
Figure 3
• Unwrap the headlight wire which is attached to the
headlight, beneath the handle panel. Wind the
headlight wire around the lower right handle until
excess slack is removed. See Figure 4.
• Plug the wire from the headlight into the alternator
lead coming from the right side of the engine
underneath the fuel tank.
Figure 4
Chute Clean-Out Tool
• This tool, along with the electric cord, is fastened
with a cable tie to the rear of the auger housing for
shipping purposes. Cut the cable tie and remove
the electric cord before operating the snow thrower.
SECTION 3: KNOW YOUR SNOW THROWER
Figure 5
WARNING: Read, understand, and follow
all instructions and warnings on the
machine and in this manual before
operating.
Traction Control / Auger Control Lock
The traction control is located on the right handle.
Squeeze the traction control to engage the wheel drive.
Release to stop. See Figure 5.
Cable
Discharge
Chute
Guide
Cable
Alternator Lead
Lamp Wire
Alternator
Lead
NOTE:
Wheels are omitted from illustration for clarity.
Traction Control /
Auger Control Lock
Shift Lever
Auger Drive Control
Skid Shoe
Auger
Headlight
Discharge
Chute
Track Steering
Control
Switch
Box
Electric
Starter
Button
Recoil
Starter
Handle
Primer
Choke
Safety
Ignition Key
Throttle
Control
Chute Tilt
Control
Heated Handles
Switch
Chute Directional
Control
Chute Clean-Out
Tool
Closed
Open
Fuel Shut-Off Valve
*If Equipped
Heated Grip