Filter
Top Products
11
SECTION 5: MAKING ADJUSTMENTS
WARNING: NEVER attempt to make any
adjustments while the engine is running,
except where specified in the operator’s
manual.
Chute Assembly
The distance snow is thrown can be adjusted by
changing the angle of the chute assembly. Move the
chute tilt control forward to decrease the distance,
toward the rear to increase.
Auger Control
Refer to Auger Control Test in the Operating Section to
adjust the auger control.
Traction Control and Shift Lever
To check the adjustment of the traction control and shift
lever, proceed as follows:
• To check the adjustment of the traction control
clutch and shift lever, proceed as follows:
• With the engine off, move the shift lever all the way
forward to the highest speed. With the traction
control lever released, push the snow thrower
forward. The unit should roll forward. Then engage
the traction control grip. The wheels should stop
turning.
• Now release the traction control grip and push the
unit again.
• Move the shift lever back to the fast reverse
position then all the way forward again. There
should be no resistance in the shift lever, and the
wheels should keep turning.
• If you have resistance when moving the shift lever
or the wheels stop when they should not, loosen
the jam nut on the traction control cable and
unthread the cable one turn.
• If the wheels do not stop when you engage the
traction control clutch grip, loosen the jam nut on
the traction control cable and thread the cable in
one turn.
• Recheck the adjustment and repeat as necessary.
Tighten the jam nut to secure the cable when
correct adjustment is reached.
WARNING: Drain the gasoline out of the
snow thrower’s tank, or place a piece of
plastic film under the gas cap to avoid
spillage BEFORE making the adjustment.
To test further for correct adjustment, if necessary,
proceed as follows:
• Tip the snow thrower forward, allowing it to rest on
the auger housing. See Figure 9.
Figure 9
• Remove the frame cover underneath the snow
thrower by removing the six self-tapping screws.
• With the traction control released, there must be
clearance between the friction wheel and the drive
plate in all positions of the shift lever.
• With the traction control engaged, the friction wheel
must contact the drive plate. See Figure 10.
If adjustment is necessary:
• Loosen the jam nut on the traction drive cable.
Adjust the cable as necessary.
• Retighten the jam nut to secure the cable when
correct adjustment is reached.
• Reassemble the frame cover.
Figure 10
NOTE: If you placed plastic film under the gas cap, be
certain to remove it before operating the snow thrower.
Frame Cover
Auger
Housing
Drive
Cable
Pivot Rod
Drive
Friction Wheel
Rubber
Gear Shaft
Plate