Filter
Top Products
18 Section 6 — Maintenance & adjuStMentS
Auger Control
Refer to the Assembly and Set-up section for instructions on
adjusting the auger control cable.
Chute Assembly
Refer to the Assembly and Set-up section for instructions on
adjusting the chute assembly.
Skid Shoes
Refer to the Assembly and Set-up section for instructions on
adjusting the skid shoes.
Chute Directional Control
To adjust the chute control rod, proceed as follows:
Remove the cotter pin from either of the holes closest to
the chute assembly on the chute rotation assembly.
2. Pull out the chute control rod until the hole in it lines up
with the hole furthest from the chute assembly on the
Figure 6-6
3. Reinsert the cotter pin through this hole and the chute
Continuous Tracks
The snow thrower is equipped with an auto-tensioner on both
the left and right sides. The system is designed to maintain
constant tension on both tracks. However, if the snow thrower
lugs, the tracks are too loose and are in need of adjustment.
See an authorized Service Dealer to have the tracks properly
Track Wheel
Auto-tensioner
Drive Lugs
Figure 6-7
Off-Season Storage
If the snow thrower will not be used for 30 days or longer, follow
the storage instructions below.
Lubricate the machine as instructed earlier in this section.
2. Store in a clean, dry area.
3. If storing the snow thrower in an unventilated area,
rustproof the machine using a light oil or silicone to coat
the snow thrower.
Clean the exterior of the engine and the snow thrower.
5. Always store the machine with the tracke lock lever in the
Normal operating position.
NOTE:
storing your engine.