Troy-Bilt 2690XP Snow Blower User Manual


  Open as PDF
of 48
 
11Section 3 — ASSembly & Set-Up
Auger Control
WARNING! Prior to operating your snow thrower,
carefully read and follow all instructions below.
Perform all adjustments to verify your snow thrower
is operating safely and properly.
Check the adjustment of the auger control as follows:
 When the auger control is released and in the disengaged


2. In a well-ventilated area, start the snow thrower engine.

3. 
thrower), engage the auger.
 Allow the auger to remain engaged for approximately ten

several times.
5. With the throttle control in the FAST (rabbit) position and

the front of the machine.
 Confirm that the auger has completely stopped rotating


position and shut off the engine. Wait for ALL moving parts
to stop before re-adjusting the auger control.
7. To readjust the control cable, loosen the upper hex screw

Figure 3-13
8. Position the bracket upward to provide more slack (or
downward to increase cable tension).
 Retighten the upper hex screw.
 
adjustment has been achieved.
 previous next