Troy-Bilt 2690XP Snow Blower User Manual


  Open as PDF
of 52
 
Auger Control

carefully read and follow all the instructions below.

is operating safely and properly.
Check the adjustment of the auger control as follows:
When the auger control is released and in the disengaged 


In a well-ventilated area, start the snow thrower engine. 2.

3.
thrower), engage the auger.
Allow the auger to remain engaged for approximately ten 

several times.
With the throttle control in the FAST (rabbit) position and 5.

the front of the machine.
Confirm that the auger has completely stopped rotating 

If the auger shows ANY signs of rotating,


ALL moving parts to stop before readjusting the auger control.
To readjust the control cable, loosen the hex jam nut on the 7.

8.


pliers and tighten the jam nut against the ferrule.

adjustment has been achieved.

11se c t i O n 2 — as s e M b l y & se t-up
 previous next