Troy-Bilt 24C-060F063 Yard Vacuum User Manual


 
5
WARNING - YOUR RESPONSIBILITY: Restrict the use of this power machine to persons who read,
understand and follow the warnings and instructions in this manual and on the machine.
NOTE: Not all safety labels may apply to your Yard Vacuum.
SECTION 2: ASSEMBLING YOUR YARD VACUUM
IMPORTANT:
This unit is shipped without gasoline or oil
in the engine. Be certain to service engine with gasoline
and oil as instructed in the separate engine manual
before operating your machine.
NOTE: Reference to right or left hand side of the Yard
Vacuum is observed from the operating position.
Removing Unit From Carton
Remove staples, break glue on top flaps, or cut
tape at carton end and peel along top flap to open
carton.
Remove loose parts if included with unit (i.e.,
operator’s manual, etc.)
Cut along corners, lay carton down flat, and remove
packing material.
Roll or slide unit out of carton and check carton
thoroughly for loose parts.
Loose Parts In Carton (See Figure 1)
Handle Assembly
•Bag
Blower Chute (If Equipped)
•Hose Assembly
Disconnecting Spark Plug Wire
Before setting up your Yard Vacuum, disconnect the
spark plug wire from the spark plug and ground to a
stud on the engine.
Figure 1
Blower Chute*
Hose
Assembly
Bag
Upper
Handle
Lower
Handle
Wing
Nuts
Rope
Guide
*If Equipped