Filter
Top Products
Assembly & Set-Up
3
7
NOTE: All references to the left and right side of the snow
thrower are from the operator’s position behind the snow
thrower.
Tools Required for Assembly
• Phillips Head Screwdriver
Unpacking the Unit
1. Cut the corners of the carton and lay the sides flat on the
ground. Remove all packing inserts.
2. Lift the upper handle and mid handle up and off the snow
thrower. See Figure 3-1.
Figure 3-1
3. Make certain the carton has been completely emptied
before discarding it.
Handle Assembly
1. Install the strain reliever on the mid handle. See Figure 3-2.
Figure 3-2
NOTE: The flared area on the lower portion of the mid
handle must face forward throughout the assembly.
Contents of Carton
• One Electric Snow Thrower • One Upper Handle • One Mid Handle
• One Chute Assembly • One Electric Snow Thrower
Operator’s Manual
• One Product Registration Card