Filter
Top Products
1. Remove components from carton
and place spreader upside down on a
padded surface. Install LH. & RH. handle
braces to frame as shown using four (4)
1/4-20 x 2 1/4” hex bolts and nuts but do
not tighten.
ASSEMBLY
3. Turn spreader upright and install end of
handle tube with DOT between handle
braces as shown. Secure with (2) 1/4-20 x
1 1/2” hex bolts and nuts.
1/4-20 x 1 1/2”
Hex Bolt
1/4-20
Hex Nut
Handle
Tube
2. Install drive wheel onto right-hand
end of axle (you can identify the drive
wheel by the cotter pin hole drilled in the
hub). Hub must face toward frame. Align
the hole in the drive wheel hub and the
hole in the axle. Secure drive wheel to
axle with 5/32 dia x 2” cotter pin. Install
the free wheel on the opposite end of
axle. Insert 5/32 dia x 1” cotter pin in the
hole near the end of axle to retain free
wheel.
DOT
RH. Handle
Brace
LH. Handle
Brace
1/4-20 x 2 1/4”
Hex Bolt
1/4-20
Hex Nut
Drive Wheel
Free Wheel
5/32 Dia x 2”
Cotter Pin
1/8 Dia x 1”
Cotter Pin