Filter
Top Products
10
To Replace the Pilot Valve Solenoid
ere are two Step 1s, depending on which version of the INFINITY Series sprinkler is being serviced.
1
With Intelligence Module:
Cut solenoid red with white stripe
and black wires.
1
Without Intelligence Module:
Cut black and white Control wires.
2
Unscrew old solenoid and dispose.
Flush plunger area with clean
water. Screw on new solenoid.
3
Strip 7/16” (11 mm) wire
from each ending.
4
Solenoid to Intelligence Module:
twist red-to-red and black-to-black.
Solenoid to Satellite Control wires:
Match wire colors with previous
installation.
Insert all ends into wire nuts.
5
Insert all wire nuts into
grease caps and snap closed.
6
Put pilot assembly and wiring
carefully back into sprinkler body
and secure with screw.