Filter
Top Products
Fuel Return Line
(93-2298)
Workman
®
3200 & 4200 Series
Relocating Fuel System Return Line - Carburetor Cleaning
Relocating the Fuel System Return Line
1. Disconnect negative battery cable from machine.
2. Drain fuel from fuel tank into an approved gasoline container.
3. Disconnect fuel lines and sending unit electrical connection and remove the tank
from the machine.
4. Fill the tank with water.
5. Drill 33/64” (13mm)
hole on flat surface
as shown in picture.
6. Loosen clamp and
unscrew fuel return
line fitting from
bottom of tank.
Discard fitting.
7. Drain water from fuel
tank and purge tank
of all water and
debris by using
compressed air for
several minutes.
8. Install fuel tank on
machine and
reconnect sending
unit electrical
connection.
9. Install Grommet (46-6560) into hole in fuel tank.
10. Press in Fitting (98-2952) into Grommet (46-6560).
11. Plug existing fuel tank return line fitting with Pipe Plug (281-10). Apply PTFE tape
or equivalent to plug before installing into tank. Tighten clamp.
12. Install new Fuel Return Line (93-2298) into Fitting (98-2952).
13. Route Fuel Return Line (93-2298) along inside vertical edge of fuel tank through
previous return line tie wrap to the carburetor.
Pipe Plug
(281-10)
Fitting
(98-2952)