Filter
Top Products
This appliance is capable of amputating hands and feet and
of throwing objects. Failure to observe the following safety
instructions could result in serious injury.
Training
• Read, understand, and follow all instructions on the appliance
and in the manual(s) before operating this appliance. Be
thoroughly familiar with the controls and the proper use of the
equipment. Know how to stop the appliance and disengage
the controls quickly.
• Never allow children to operate the appliance. Never allow
adults to operate the appliance without proper instruction.
• Keep the area of operation clear of all persons, particularly
small children.
• Exercise caution to avoid slipping or falling.
Preparation
• Thoroughly inspect the area where the appliance is to be
used and remove all doormats, sleds, boards, wires, and
other foreign objects.
• Do not operate the appliance without wearing adequate winter
garments. Avoid loose tting clothing that can get caught in
moving parts. Wear footwear that will improve footing on
slippery surfaces.
• Do not attempt to clear snow from a gravel or crushed rock
surface. This appliance is intended for use only on paved
surfaces.
• Never attempt to make any adjustments while the motor
is running (except when specically recommended by
manufacturer).
• Always wear safety glasses or eye shields during operation or
while performing an adjustment or repair to protect eyes from
foreign objects that may be thrown from the appliance.
Operation
• Do not put hands or feet near or under rotating parts. Keep
clear of the discharge opening at all times.
• Exercise extreme caution when operating on or crossing
gravel drives, walks, or roads. Stay alert for hidden hazards
or trafc.
• After striking a foreign object, stop the motor, remove the
ignition key, thoroughly inspect the appliance for any damage,
and repair the damage before restarting and operating the
appliance.
• If the unit should start to vibrate abnormally, stop the motor
and check immediately for the cause. Vibration is generally a
warning of trouble.
• Stop the motor whenever you leave the operating position,
before unclogging the rotor blade housing or discharge chute,
and when making any repairs, adjustments or inspections.
• When cleaning, repairing, or inspecting the appliance, stop
the motor and ensure that the rotor blades and all moving
parts have stopped.
• Exercise extreme caution when operating on slopes.
• Never operate the appliance without proper guards and other
safety protective devices in place and working.
• Never direct the discharge toward people or areas where
property damage can occur. Keep children and others away.
• Do not overload the capacity of the appliance by attempting to
clear snow at too fast a rate.
• Look behind and use care when backing up with the
appliance.
• Disengage power to the rotor blades when the appliance is
transported or not in use.
• Never operate the appliance without good visibility or light.
Always be sure of your footing, and keep a rm hold on the
handles. Walk; never run.
Clearing a Clogged Discharge
Chute
Hand contact with the rotating rotor blades inside the discharge
chute is the most common cause of injury associated with
snowthrowers. Never use your hand to clean out the discharge
chute.
To clear the chute:
• Shut the motor off!
• Wait 10 seconds to be sure the rotor blades have stopped
rotating.
• Always use a clean-out tool, not your hands.
Maintenance and Storage
• Check all fasteners at frequent intervals for proper tightness
to be sure the equipment is in safe working condition.
• Always refer to this Operator’s Manual for important details if
the appliance is to be stored for an extended period.
• Maintain or replace safety and instruction labels, as
necessary.
• Run the appliance a few minutes after throwing snow to
prevent freeze-up of the rotor blades.
SAVE THESE INSTRUCTIONS
Safety and Instructional
Decals
Important: Safety and instruction decals are located near
areas of potential danger. Replace damaged or lost decals.
114-8985
1. Push the button on the
side of the handle, then
grip and squeeze the
trigger to engage the rotor.
2. Release the trigger and
safety interlock switch to
disengage the rotor.
2