Filter
Top Products
ASSEMBLY
Assembly Section 2-19
MAIN BOOM INSTALLATION
Install the boom swivel into the main frame as shown in the parts section using a
hoist. Line up holes in swivel and main frame for large swivel pin and insert pin. Secure
with hardware as shown.
Attach the inner end of the main boom to the swivel bracket with the cylinder anchors
positioned upward, and at a right angle to the tractor. Secure it with the horizontal hinge
pin. Secure the hinge pin in the boss with capscrews, etc. (see parts section).
Attach the butt end of the main boom cylinder to the swivel bracket anchor with the
special “bracket head” cylinder pin and roll pin shown in parts section.
Install the travel lock on the rod end of the main boom cylinder. This should be facing
the butt end of the cylinder after installation.
Install the fittings and hoses to the main boom cylinder per parts section.
GREASE HINGE PIN ZERKS ON BOOM AFTER ASSEMBLY, ONCE UNDER
LOAD WITH BOOM ELEVATED AND AGAIN AT REST WITH BOOM SUPPORTED
(ASM-C-0013)
DECK ATTACHMENT
Attach the head to the secondary boom using the pins and hardware shown in the parts
section to attach linkages. Install the square tube on the top of the head into the head mount
and secure using the mounting plate and hardware as shown. The mount should be
positioned to the left side of the cutter head. Install the deck pivot cylinder using the pins and
hardware also shown in the parts section.
Connect the fittings and hoses from the pivot cylinder to the small preformed tubes on the
boom arm. Connect the fittings and hoses from the motor to the large preformed tubes on
the boom arm.
Connect all remaining hoses from the control valve to the cylinders and / or preformed
tubes on the boom arm. Refer to parts section for diagrams.
Before proceeding to the final preparation step double check the complete
assembly from the main frame to the cutter head against the diagrams in the
parts section for proper placement and assembly of all components...
(ASM-C-0060)