Filter
Top Products
ASSEMBLY
Assembly Section 2-18
3-POINT BOOM REST MOUNTING
install the boom rest onto the 3-point hitch using the pins as shown in the parts
illustration. Adjust the bottom arms so the boom clears the tractor fender (X),
adjust the top link so that the boom saddle is approximately level with the ground.
Re-adjust once the boom is completely installed and operable. Adjust the top link
until the boom is properly seated in the boom rest (Z) and no part of the boom
(including hoses) comes into contact with the tractor cab. Next, using the side
turnbuckles, adjust the boom and boom rest all the way to the right for proper
width restrictions. Check your local width regulations before transporting your
mower. You may need to adjust the boomrest for overall height as well (Y)... (ASM-
C-0054)
AXLE BRACE MOUNTING
Position the right axle brace under the tractor right hand side. Raise the brace up to
the matching mounting holes in the main fame and rear axle housing. Note the right side
brace is installed on outside edge of the main frame and the left side brace is installed on
the inside edge of the main frame. Pictures below show right side brace installation.
Install the clamp plate with capscrews, washers and nuts as shown in the main frame
parts section. Apply Loc-Tite to the threads and torque to the values noted in the torque
chart located in the maintenance section of this manual.
(ASM-JD-0072).