Tiger JD 5101E Lawn Mower User Manual


 
Side & Rear flail Maintenance Section 4-15
MAINTENANCE
ADJUSTING THE CABLE LIFT
Extend the outboard cylinder until the mower deck touches its stop on the draft
beam as shown. NOTE: Make sure the cable turnbuckle is loose enough to allow
the cylinder to reach full extension before the head reaches the stop. Now hold the
head against the stop and tighten the turnbuckle until the cable is tight. Lower and
raise the head to check the adjustment. The head should touch its stop at the same
time the cylinder reaches full extension. Tighten turnbuckle lock nuts securely after
adjustment is complete.
DRIVE SHAFT YOKE, U-JOINT & STUB SHAFT
With engine stopped, inject Lithium-Complex extreme pressure grease
conforming to NLGI2-ISO 320 specifications into universal joints and slip yoke untill
grease appears at the seal. Grease them daily or every 8 hours.